RoofCalc - Roofing Calculator
ROOF FRAMING CALCULATOR FOR CARPENTERS
ROOFING & FRAMING CARPENTRY CALCULATOR.
Metric or US/Imperial it is used by carpenters around the world.
ROOF FRAMING:-
◆ Rafter,Hip/Valley Lengths - 6 variations;
◆ Hip/Valley Lengths - 6 variations;
◆ Cut Angles, including for Compound Saw for plumb, side & seat cuts and purlins-side & down cuts;
◆ Template sizes for the same cuts - adjustable template;
◆ List of Creepers/Jack Rafters(US);
◆ Pitch in inches (US), degrees, D:M:S;
◆ Rise:Run - decimal ratio or percentage gradient or inches in 12" (US).
◆ Full Span or half span.
◆ Adjusted calculations when one pitching plate/wall is higher than the other;
◆ Height from plate with or without adjustment for ridge;
◆ Area/Diagonal;
TIMBER SET OUT:-
Calculate and print list of stout positions.
◆ Equally spaced, maximum spacing or fixed spacing options;
◆ Insets at start and end.
◆ Lists of set out positions;
◆ Print, email or message lists and even makes notes on first;
STUD WALLS:-
◆ Raked or flat walls;
◆ Number and total length of studs, est. noggins/blocking, top (cut length) and bottom plates.
◆ Adjust for and extra end stud and also alignment (if required) to drywall sheet joins.
◆ Wall Area and Estimated drywall/(Gyprock) sheets and timber volume;
◆ Template sizes for the same cuts - adjustable for different sized template;
◆ Lists of stud lengths, stud positions on bottom and top Plates (raked);
◆ Print, email or message lists and even makes notes on first;
◆ Estimate Cost - Timber & Sheeting;
◆ Align sheets on width,length or no sheets.
◆ When raked adjust any of long side height or pitch (degrees/Inches/rise:run).
CONVERTER:-
◆ Convert Lengths, Area, Volume: Metric and US/Imperial.
◆ Work in Decimal units or Yds/Ft/In/Fraction format to Metric, decimal US.
GENERAL CALCULATOR WITH TAPE:
◆Calculate (add, subtract etc) directly in feet / inches / fractions or decimals.
◆Common functions for quick calculation
EXTENSIVE HELP:
Extensive help - Single touch brings up brief help at top of screen ,tap twice on most buttons for more info.